Removing Insert With Molding For Dashboard On Passenger's Side

Information 

• The number of fastening screws, fixing clips, plug connections, holders and trim panels can vary depending on equipment. 
• The illustrations for removing and installing the drive mechanism are shown only on one equipment variant and may differ from the actual equipment variant. 
• Some steps must be carried out automatically. 
• Some of the repair illustrations show only one side of the vehicle. 

Information 

Only installed in vehicles without a cupholder. The insert with molding can only be removed as a complete unit.

1. Vehicles without cupholder: Remove insert with molding -6-  . → REMOVING CUPHOLDER
   Fig 1: Removing Molding

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.