Teaching Additional/Telephone Handset
CAUTION:
Voltage drop
- Risk of damage to control unit
- Fault entries in the control unit
- Coding in the control unit is aborted
- Malfunctions in control unit, even during programming
→ Ensure that the power supply is not interrupted during programming.
→ Connect a battery charger with a current rating of at least → Nominal value: 40 A to the vehicle battery.
Information
Later versions of the software may display slightly different text or require a slightly different procedure. The instructions you receive from the Tester itself take precedence over this description.
- PIWIS Tester II 9818 must be connected to the vehicle before starting the Tester. Switch on ignition.
- Select the vehicle type and start the diagnostic application.
- Select PCM control unit and Drive links/checks and press [F12] to continue.
- Engage telephone handset in the charging cradle.
- Select the Teach handset function and press [F12].
- Start the activation process by pressing [F8].
- Follow the instructions on the Tester. The entry Activation (value = on) is required. Press [F11] to go back.
- Check the function of the handset.