Notes On Removing And Installing The Battery

NOTE: A battery charger for providing an external power supply or for jump-lead starting is connected directly to the battery in the vehicle.

Risk of damage to the battery sensor.
Battery sensor sends incorrect battery values to the vehicle electrical system.

→ Always connect a battery charger for providing an external power supply or for jump-lead starting to the defined connections in the engine compartment. → 2X00IN BATTERY TRICKLE CHARGING

Information

The battery is located in the luggage compartment under the loadspace floor.
In order to avoid triggering the siren in vehicles with an additional alarm siren, the battery must be disconnected while the ignition is on!
All loads must be switched off beforehand! Remove ignition key!
Never disconnect battery with engine running!
Never start engine without a securely connected battery!
To prevent damage to the battery, the battery terminal clamps should only be attached by hand - without excessive force.
Check that the battery is seated correctly after installation. A loose battery presents other dangers, such as: - Reduced service life due to vibration damage. - Noises. - Damage to the battery housing from mounting parts. - Inadequate crash safety.