Removing Gearshift Bracket
- Remove design cover from Y-shaped pipe.
- Remove Y-shaped pipe from intake manifold.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Unscrew fastening screws -arrows-
from gearshift bracket.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Detach connector -arrow-
from transmission.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Position transmission jack under transmission support.
- Unscrew fastening screws from transmission support.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Lower transmission on transmission support by max. 25 mm.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Lever off cable ends -1-
on the transmission using disassembly tool Nr.21
.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Remove tab washers -2-
for the operating cables from the support using a screwdriver.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Remove gearshift bracket together with operating cables.
- Align gearshift bracket in neutral position using locking bridge 9619/2
.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Measure excess operating cable -X-
at the cable end and write it down. The dimension -X-
is needed for pre-positioning during installation.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Unscrew fastening screws -arrows-
from the bottom of the gearshift bracket and remove cover.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Release adjuster from the gearshift bracket. To do this, release the catch using a screwdriver -arrow-
.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Remove safety clips -arrows-
from the gearshift bracket.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Remove operating cables from the gearshift bracket.