Injectors - V6
WARNING: This page is about a different variant/trim than selected.
Information
Please note the following for the V6 =>
- The repair concepts for the V6 are the same as for the V8.
- The special features and component deviations are listed and shown in
> 1001IN TIGHTENING TORQUES, TIGHTENING SEQUENCES AND ASSEMBLY OVERVIEWS
- More significant deviations are shown in separate descriptions.
- If no special features are specifically highlighted, the assembly and adjustment instructions for the V8 apply.
- On the V6, the twin holder must be removed first so that the single holder with the fuel injector can be removed.
- Cylinder 1 must always be installed first with one single holder (as for cylinder 6).
- The holders are not interchangeable.
- The twin holders are identical to the twin holders used on the V8.
Fuel injectors
| 1 | Twin holder (retainer for two injectors) => for cylinders 2 to 3 and 4 to 5 |
| 2 | Screw, M8 x 30 |
| 3 | Single holder (retainer for one injector) => for cylinders 1 and 6 |
| 4 | Injector (high-pressure fuel injector) |