Removing Rear Power Window Motor

→ Switch off electric power to drive motor.

→ Make sure it does not switch on again.

→ Check that there is no electric charge.

Information 

• Some of the repair illustrations show only one side of the vehicle. 
• Naturally, some steps also have to be performed on the opposite side of the vehicle as well. 
• These must be carried out as a mirror image of the steps shown for the front and rear. 

Information 

The end positions of the power windows are deleted from the control unit when the electric connectors are disconnected and connected.

1. Switch off ignition and remove remote control (hand-held transmitter).
2. Unscrew three fastening screws -1-  for the power window motor.
   Fig 1: Removing Power Window Motor

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. Pull power window motor out of the splines.
4. Release plug connection -a-  and disconnect it -B-  .
   Fig 2: Disconnecting Plug Connection

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.