LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Panamera 4 Edition >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> 53 - Body Rear - PANAMERA (970) >> WM 532519 Removing And Installing Rear-End Well (Except PANAMERA S E-Hybrid, PANAMERA S Hybrid, PANAMERA Executive, PANAMERA GTS, PANAMERA Turbo S, PANAMERA 4S Sport Edition, PANAMERA 4 Executive, PANAMERA Platinum Ed., PANAMERA 4 Platinum Ed.) >> Preparing Rear-End Well >> Preparing Rear-End Well (Re-Installing Well)

Preparing Rear-End Well (Re-Installing Well)

NOTE: Possible adhesion problems when bonding body parts
  • Several applications of primer can result in adhesion problems during bonding.

→ prime-coated spare parts must not be primed again before installation

→ only apply activator to prime-coated spare parts.

Information 

  1. Activate the bonding area.
    1. 1.1. Apply activator -h3-  to the prime-coated surface.
      Fig 1: Applying Activator
      G09809807Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals