Loosening Main Wire Harness In Luggage Compartment
NOTE:
Incorrect handling of main wire harness
- Risk of damage to lines
→ The main wire harness contains all airbag lines, antenna lines and optical waveguides.
→ The main wire harness must not be separated and is always replaced as a complete wire harness when carrying out extensive repairs.
→ If individual lines are damaged, shut off these lines and install new lines. Lay the new lines along the main wire harness and secure them to the main wire harness.
- Remove supports for luggage compartment cover.
- 1.1. Unscrew fastening screws -1- for luggage compartment cover support on the left and right.
- 1.2. Remove luggage compartment cover support on the left and right -arrow- .
- Loosen rubber sleeve -1- and pull out cable for tail light -2- on the left and right -arrow- .
- Unclip cable for tail light at the left and right.
- Release cable duct at the left and right.
- 4.1. Unclip cable duct -1- on the left and right -arrow- .
- 4.2. Disconnect ground points -2- on the left and right.
- Disconnect cable for trailer hitch.
- 5.1. Release and pull off electric plug connection for trailer hitch.
- 5.2. Unclip cable for trailer hitch -1- (-arrow A- ).
- 5.3. Guide cable for trailer hitch -1- through the rubber sleeve -2- (-arrow B- ).
- Remove control unit for parking brake. → REMOVING CONTROL UNIT FOR ELECTRIC PARKING BRAKE
- Disconnect electric plug connection from control unit for parking brake.
- Remove TPM control unit and holder. → REMOVING TPM CONTROL UNIT
- Disconnect electric plug connection from TPM control unit.
- Disconnect electric plug connection for filler flap opener. → REMOVING SWITCHING ELEMENT FOR FILLER FLAP
- Remove side trim panel support.
- 11.1. Unscrew fastening screws -1- for side trim panel holder.
- 11.2. Remove side trim panel support.
- Disconnect electric plug connection for rear shock absorber (spring damper). → REMOVING VIBRATION DAMPER
- Remove PASM control unit and holder. → REMOVING PASM CONTROL UNIT
- Disconnect electric plug connection from PASM control unit.
- Disconnect electric plug connection for ABS. → Removing Wire Harness For Anti-Lock Brake System (ABS)
- Unclip supply lines for ABS wire harnesses at the underbody, which go to the MAIN WIRE HARNESS IN THE LUGGAGE COMPARTMENT .
- Make sure that all electric plug connections going to the main wire harness in the luggage compartment are disconnected.
- Release rubber sleeve and pull lines up out of the underbody in the luggage compartment area.
- Release and disconnect electric plug connection for rear three-point belt at the left and right.
- Release and disconnect electric plug connection for head airbag unit at the left and right.
- Release and disconnect electric plug connection for heating element for rear backrest at the left and right.
- Release and disconnect electric plug connection for wire harness for tailgate at the left and right.
- Remove sound absorber on rear wheel housing at the left and right.
- Release and disconnect electric plug connection for acceleration sensor on the wheel housing -arrow- .
- Loosen fastening nut for ground point on the left wheel housing in the direction of travel -arrow- and remove cable.
- Loosen fastening nut for ground point on the right wheel housing in the direction of travel -arrow- and remove cable.