LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Panamera 4 Edition >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Fuel System >> 24 - Fuel System - Electronic Ignition -- PANAMERA (970) >> WM 248019 Removing And Installing Pressure Sensor (PANAMERA, PANAMERA 4) >> Removing And Installing Pressure Sensor

Removing And Installing Pressure Sensor

  1. Remove pressure sensor.
    1. 1.1. Release electric plug connection for the pressure sensor -1-  and disconnect it.
    2. 1.2. Unscrew screw -2-  .
    3. 1.3. Remove pressure sensor -1-  by prying and turning it slightly.
  2. If the sealing ring is damaged, replace the pressure sensor.
  3. Insert pressure sensor -1-  into the intake-air distributor by turning it slightly.
    1. 3.1. Screw in and tighten screw -2-  . Tightening torque 3 Nm (2 ftlb.)
    2. 3.2. Plug in and lock electric plug connection for the pressure sensor -1-  .
      Fig 1: Identifying Pressure Sensor On Intake-Air Distributor
      G09805960Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals