Preparing Rear-End Well (Replacing Well)

1. 1.1. Fit cutting tool -c-  with the flashing knife -d-  and remove adhesive residue, ensuring that a surface coating of adhesive residue remains.

Information 

• The remaining adhesive helps new adhesive to stick. Keep cut surfaces clean and free of grease and do not clean with cleaning solution. 
  Fig 1: Cutting Back Adhesive Bead

  Courtesy of PORSCHE CARS NORTH AMERICA, INC.

1. 2.1. During long idle periods, apply activator -h3-  to the adhesive residue that was cut back.
   Fig 2: Applying Activator Bonding Section

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.