Installing Wiper Motor

→ Switch off electric power to drive motor.

→ Make sure it does not switch on again.

→ Check that there is no electric charge.

1. Position wiper motor on the wiper linkage.
2. Screw in and tighten fastening screws -3-  . →→ Tightening torque: 12.5 Nm (9 ftlb.) 
3. Coat ball joint -2-  with commercially available lubricant.
4. Press push rod -1-  onto the ball joint -2-  (-B-  ).
   Fig 1: Installing Fastening Screw

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.