LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Panamera 4 Edition >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> 57 - Door Front, Central Locking System -- PANAMERA (970) >> WM 576655 Replacing Additional Window Frame Seal (Except PANAMERA Executive, PANAMERA 4S Sport Edition, PANAMERA 4 Executive) >> Replacing Additional Window Frame Seal

Replacing Additional Window Frame Seal

Fig 1: Identifying Installation Position Of Additional Window Frame Seal
G09810394Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  1. Remove additional seal.
    1. 1.1. Unclip additional seal at the top -A-  .
    2. 1.2. Lever off additional seal -B-  and remove it.
      3. Fig 2: Removing Additional Window Frame Seal
      G09810395Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Information 

    • Immediately before sticking on, wash off the areas on which you intend to stick the seal using isopropanol to ensure that all traces of silicone, grease and oil are completely removed. 
  2. Install new additional seal for the window frame.
    1. 2.1. Clip in additional seal at the top.
      Fig 3: Clipping In Additional Seal
      G09810396Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    2. 2.2. Position front edge of additional seal on the guide rail for the corner window pane.
    3. 2.3. Pull off the protective film on the front edge -A-  and pull it out under the additional seal. Press additional seal on evenly.
    4. 2.4. Align the additional seal towards the rear.
    5. 2.5. Pull off the protective film on the lower edge -B-  and pull it out under the additional seal. Press additional seal on evenly.
    6. 2.6. Align the additional seal at the rear edge.
    7. 2.7. Pull off the protective film on the rear edge -C-  and pull it out under the additional seal. Press additional seal on evenly.
      8. Fig 4: Sticking On Additional Seal
      G09810397Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals