Adjusting Lock Peg

Information 

• The striker pin can be adjusted by changing the plasticity of the adjusting element in the B-pillar. 
• The setting is retained when the striker pin is removed. 
  Fig 1: Adjusting Element For Striker Pin

  Courtesy of PORSCHE CARS NORTH AMERICA, INC.

1. Loosen fastening screws -2-  .
2. Move lock peg outwards.
   1. 2.1. Move the lock peg -1-  outwards (if necessary) using a slide hammer kit Nr.168  .
   Fig 2: Moving Lock Peg Outwards
   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. Adjust the lock peg back/down/up (if necessary).
   1. 3.1. Move catch bar -1-  to the required position using a plastic hammer.
   2. 3.2. Carefully close the door and check adjustment.
   Fig 3: Adjusting Lock Peg
   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. Tighten fastening screws -2-  to the specified tightening torque Tightening torque 23 Nm (17 ftlb.)  until secure.