Subsequent Work
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
- Install oil guide housing and oil pan.
- Fitting new joint flange behind the vibration damper.
> 137419 REMOVE AND INSTALL CRANKSHAFT SEALING RING FOR BELT PULLEY/VIBRATION DAMPER
- Check the timing.
TDC position of camshafts
Turn the engine two turns clockwise to TDC of cylinder 1 and lock the belt pulley using 9595/1 - locating pins .
Check the position of the camshafts -Arrows- . The surfaces for the camshaft adjustment must be horizontal.
- 3.2.1 If the control chain is still in the same position as it was during removal, remove 9595/1 - locating pins and continue with Step 4.
- 3.2.2 Only set the timing if the control chain has jumped.
- Fit vibration damper.
- Install both valve covers.
- Mount drive belt. For details, see
- Fit coolant hoses in front of the chain housing cover. Don't forget the holder. Coolant return line on turbo, for example
Coolant return line on turbo, for example
1 Connection piece on alternator 2 Connection piece screw 3 Screw, M6 x 20 4 Coolant return line 5 Coolant return hose assembly 6 Bracket 7 M6 screw Aluminium screw; always use new aluminium screws 8 Clip - Filling engine oil. For details, see
> 170117 DRAINING AND FILLING ENGINE OIL (CHANGING ENGINE OIL)
- Flange the transmission.
> Refer to 343527 Removing and mounting transmission in the appropriate service information.
or
- Installing engine.