Low-Pressure Fuel System Bleeding
WARNING: This page is about a different car, the 2018 Land Rover Discovery and 2017 Land Rover Discovery. However, it is still accessible from the selected car via links, so may be relevant.
| 19.50.23 | FUEL SYSTEM BLEED - LOW PRESSURE | 3 000 CC, TDV6 | 0.1 |
WARNING:
- Avoid flames, sparks or lighted substances.
- Wait for a minimum of 1 minute after the engine has stopped before carrying out any repair to the fuel injection system.
CAUTION:
Make sure that the area around the component is clean and free of foreign material.
- This procedure is necessary if any of the following fuel system components are removed, disconnected or replaced: Fuel tank, low pressure fuel lines or the fuel filter.
-
CAUTION: Do not start the engine.
Repeat the following procedure 3 times.
- Set the ignition to the ON position.
- Wait for 65 seconds.
- Set the ignition to the OFF position.
- Start the engine and idle for 60 seconds