LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Macan Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 648 (47 Brakes- Brake Hydraulic System, Regulator, Booster -- (95B) MACAN) >> WM 474119 Removing And Installing Rear Brake CALLIPER (Except MACAN Sport Edition) >> Removing And Installing Rear Brake Calliper >> Removing Rear Brake Calliper

Removing Rear Brake Calliper

WARNING: This page is about a different car, the 2018 Porsche Macan and 2017 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
G11977650Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  1. Fastening screw for EPB actuator
  2. EPB actuator
  3. Sealing ring
  4. Fastening screw securing brake calliper to calliper carrier
  5. Boot for guide pin
  6. Fastening screw securing brake calliper to wheel bearing housing
  7. Calliper carrier
  8. Brake calliper
  9. Ventilation valve
  10. Dust boot
  11. Pad retaining bracket
  12. Brake pad
  13. Cable for brake pad wear indicator
  14. Cable holder for brake pad wear indicator
  1. Disconnect electric plug connection for brake pad wear indicator at the brake calliper.
  2. Release and disconnect electric plug connection -1-  on the speed sensor.
    G11977651

    Rear speed sensor 

  3. Disconnect brake line -2-  at the brake calliper and collect brake fluid in a suitable container.
  4. Close off brake line using a suitable stopper.
  5. Unscrew fastening screws -3-  on the calliper carrier.
    G11977652

    Mounting for brake calliper 

scientia non olet · About LEMON Manuals