LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Macan Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 625 (13 - Engine - CRANKGEAR, Pistons -- (95B) MACAN) >> WM 137419 Removing And Installing Sealing Ring For Crankshaft Pulley (MACAN Only) >> Removing Sealing Ring For Crankshaft Pulley

Removing Sealing Ring For Crankshaft Pulley

WARNING: This page is about a different car, the 2018 Porsche Macan and 2017 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pressure piece T10368  must be screwed on. → Pressure piece -T10368- 
    G11980362

    Pressure piece -T10368- 

  2. Pull off sealing ring using puller hook T40274  . → Pulling off sealing ring 
    G11980363

    Pulling off sealing ring 

    NOTE:
    • If the joint flange on the pulley or the surface on the crankshaft stub is slightly rusted, polish the rust off with a special polishing pad. 
    • If there is bad corrosion or deep grooves, replace these components. 
  3. Clean running and sealing surfaces.
scientia non olet · About LEMON Manuals