LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Macan Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 625 (13 - Engine - CRANKGEAR, Pistons -- (95B) MACAN) >> WM 131020 Removing And Installing Pistons (MACAN Only) >> Removing Pistons

Removing Pistons

WARNING: This page is about a different car, the 2018 Porsche Macan and 2017 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Mark installation position of the piston and its allocation to the relevant cylinder.

    Installation position: Arrow on piston crown is pointing to the pulley.

  2. Mark installation position of the connecting rod and its allocation to the relevant cylinder.
  3. Remove connecting-rod bearing cap and pull piston with connecting rod up and out.
  4. Remove circlips from the piston pin eye.
    NOTE:
    • If the piston pin is stiff, heat the piston to around 60 °C (140 °F). 
  5. Drive out piston pin using drift VW 222 A  .
scientia non olet · About LEMON Manuals