Subsequent work
WARNING: This page is about a different car, the 2018 Porsche Macan and 2017 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
Information
- The speed sensor must be inserted using Optitemp (Optitemp LG2, 25-ml spray can available under Part No. 000.043.204.21) .
- The bore for mounting the speed sensor must be free of dirt .
- Observe correct tightening torques .
- Insert speed sensor -2-
and tighten fastening screw -1-
. Tightening torque 8 Nm (6 ftlb.)
Mounting for speed sensor
- Position cover plate for brake disc -2-
and tighten fastening screws -1-.
Tightening torque 10 Nm (7.5 ftlb.)
Mounting for brake cover plate (shown installed as an example)
- Install wheel bearing housing. → 425219 REMOVING AND INSTALLING REAR WHEEL BEARING HOUSING
95BAA1, 95BAB1, 95BAD1, 95BAF1, 95BAJ1, 95BAK1, 95BAS1, 95BAX1, 95BAY1, 95BAZ1
Model year as of 2014, Model year up to 2020
C00, C02, C05, C06, C07, C08, C09, C10, C11, C12, C13, C14, C15, C16, C17, C18, C19, C20, C21, C22, C23, C24, C25, C26, C27, C28, C32, C33, C34, C35, C36, C37, C38, C39, C41, C45, C45, C46, C96, C97, C98, C99