Possible causes, elimination, notes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
This fault is only stored in the memory if the voltage at the input of the convertible-top potentiometer exceeds or falls below the operating range.
- Switch ignition off and remove ignition key. With test adapter 9619, 9636 and pin template 9636, measure the resistance of the convertible-top potentiometer at row 1, pins 12, 21 and 24 with the ohmmeter. If the display "INFINITY" ohm appears, the convertible-top potentiometer must be replaced.
Refer to REMOVING AND INSTALLING POTENTIOMETER FOR CONVERTIBLE-TOP INTERROGATION .
- Switch on the ignition and measure at row 1, pins 12 and 21, with the voltmeter; nominal value (display) 0.4 - 4.4 volts.
If there is no voltage display, replace the control module.
- Calibrate the convertible top