Installing Seal For Convertible-Top Compartment Lid
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Information
- Before replacing seal, check the existing seal for signs of damage (tears, crushed areas, etc.). If there are signs of damage, the seal must be replaced.
- The seal is pressed onto the flange without any additional sealant.
Information
- Pay particular attention to the areas near the tight roundings for correct installation; there must be no deformation or stretching.
- Push in seal in the upper area of the trim panel on the Targa crash bar, fit it all the way around and press it on.
- Check that the seal is seated correctly.