LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Macan Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 309 (61 - Convertible Top, Hardtop -- 911 CARRERA (991)) >> WM 619219 Removing And Installing Hinge For Convertible-Top Compartment Lid (CARR. CABRIO, CARR. S CABRIO, CARRERA GTS CABRIO, TARGA 4, TARGA 4S, TARGA 4 GTS, CARR. 4 CABRIO, CARR. 4S CABRIO, CARR. 4 GTS CABRIO, Turbo S CABRIO) >> Installing Hinge For Convertible-Top Compartment Lid

Installing Hinge For Convertible-Top Compartment Lid

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information 

Check that the water drip pan is seated correctly close to the rear water drain.

  1. Prime the sealing surfaces of the hinge on the body using a corrosion protection touch-up stick.
  2. Position the hinge at the previously marked area and tighten fastening nuts and fastening screw.
  3. Install hydraulic cylinder for convertible-top compartment lid.
  4. Clip in wiring harness for convertible-top compartment lid.
  5. Tighten fastening nuts to Tightening torque 23 Nm (17 ftlb.)  .
  6. Tighten fastening screw to Tightening torque 23 Nm (17 ftlb.)  .
scientia non olet · About LEMON Manuals