LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Macan Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 309 (61 - Convertible Top, Hardtop -- 911 CARRERA (991)) >> WM 619119 Removing And Installing Additional Flap (CARR. CABRIO, CARR. S CABRIO, CARRERA GTS CABRIO, CARR. 4 CABRIO, CARR. 4S CABRIO, Turbo CABRIO, CARR. 4 GTS CABRIO, Turbo S CABRIO) >> Removing Additional Flap >> Notes

Removing Additional Flap: Notes

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Additional Flap Position
G09994629Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  1. Perform emergency operation of additional flaps as described in the Driver's Manual.
    1. 1.1. Loosen motor.
    2. 1.2. Move additional flaps to the open position.
  2. Disconnect plug connection for motor.
    Fig 2: Disconnecting Wiring Harness Plug Connection
    G09994630Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Information 

    Screw is accessible through the cut-out in the additional flap.

    Fig 3: Locating Threaded Joint Of Additional Flap
    G09994631Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Unscrew and remove fastening screws on the guide flaps.

    Information 

    • The illustrations for the procedure show only one side of the vehicle. 
    • All steps must also be completed on the opposite side of the vehicle. 
    • These must be carried out as a mirror image of the steps shown. 
      Fig 4: Locating Side Fastening Screws
      G09994632Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  4. Unclip wire harness.
    Fig 5: Removing Wire Harness
    G09994633Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  5. Remove additional flaps.
    Fig 6: Removing Additional Flaps
    G09994634Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    1. 5.1. Press off clip connection at the drive -arrow A-  .
    2. 5.2. Pull additional flaps with drive up and off -arrow B-  .
  6. Remove drive mechanism.
    Fig 7: Loosening Drive Mechanism
    G09994635Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    1. 6.1. Loosen clamp -2-  .
    2. 6.2. Pull additional flap -1-  with actuating cable off the drive.
  7. Disassemble additional flap
    Fig 8: Disassembling Additional Flap
    G09994636Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    1. 7.1. Press additional flap -1-  down in the guide rail -2-  .
    2. 7.2. Press lever out of the guide track -arrow-  .
    3. 7.3. Pull additional flap -1-  fully out of the guide rail -2-  .
      Fig 9: Removing Additional Flap
      G09994637Courtesy of PORSCHE CARS NORTH AMERICA, INC.