Loosening Front Apron At The Bottom

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

The number of fastening screws, fixing clips, plug connections, holders and trim panels can vary depending on equipment.
The illustrations for removing and installing the drive mechanism are shown only on one equipment variant and may differ from the actual equipment variant.
Some steps must be carried out automatically.
Some of the repair illustrations show only one side of the vehicle .

Fig 1: Identifying Front Apron Installation Position

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Unscrew fastening screws at the bottom -2- of the front apron -1- .

Fig 2: Identifying Front Apron Screws
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

On Turbo and Turbo S vehicles, disconnect hose connection for front spoiler pneumatic system.
Unscrew and remove fastening screws at the bottom of the air deflector vanes.
1. 2.1. Unclip air deflection vane -1- and swivel it downwards.
  
  Fig 3: Removing Air Deflector Vane
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  
  Information
  
  Air hoses are color-coded and must not be interchanged.
  
  Observe marking for insertion depth of hose connection.
  
  Hoses must not be kinked.
2. 2.2. Pull hose connections down through the opening and disconnect them at the hose connections -1- .
  
  Fig 4: Disconnecting Hose Connection
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.