LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Macan Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 278 (47 Brakes- Brake Hydraulic System, Regulator, Booster -- 911 CARRERA (991)) >> WM 474119 Removing And Installing Rear Brake CALLIPER (Except CARRERA "Edition", CARRERA Cabriolet "Edition", CARRERA 4 "Edition" CARRERA 4 Cabriolet "Edition") >> Removing And Installing Rear Brake Calliper >> Removing Rear Brake Calliper

Removing Rear Brake Calliper

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the plug connection for the brake pad wear indicator and detach it from the holder.
  2. Loosen fastening screws in the holder for the brake pad wear indicator cable and for the brake line from the brake calliper.

    Disconnect the brake line at the brake calliper and collect brake fluid in a suitable container.

  3. Close off the brake line and brake calliper bore using suitable stoppers.
  4. Detach the brake calliper from the wheel bearing housing (wheel carrier) -arrows-  and remove it.

    If the edge of the brake disc is protruding at the outer diameter, first reset the brake pads slightly and evenly.

    Fig 1: Locating Brake Calliper Screws
    G09993312Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals