Installing Bulb For Fog Light

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Insert a new bulb in the holder and secure it with the clip.
You will see a mark -x- on one of the support lugs on the bulb holder. This mark must be pointing to the rear (i.e. against the direction of travel) during installation. This is the only way to install the bulb holder correctly.

Fig 1: Identifying Installation Position Of Fog Light Bulb Holder
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
The bulb holder containing the bulb (without cover) is positioned in the mounting point in the fog light -x- and is locked by turning it clockwise. Check that the bulb is seated securely.

Fig 2: Installing Bulb Holder
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Place the plug connection for the bulb -2- along with the connector in the cap. Insert the connector -1- in the cap into the bulb holder.

Fig 3: Connecting Plug Connections For Bulb
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit the cap and lock it (locking direction is shown on the cap).

Fig 4: Locking Cap
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

Check the breather hose -1- for signs of damage and check that it is seated securely.

Fig 5: Identifying Breather Hose
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

If in doubt, replace the breather hose.
Push in the electric connector for the bulb until it clicks into place.
Check that the fog light bulb is working.