Technical Values
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Transmission/engine connection | Tightening torque | 85 Nm (63 ft. lb.) | |||
| Pulse sender to transmission bell housing | Tightening torque | 10 Nm (7.5 ft. lb.) | |||
| Hydraulic line of clutch control | Tightening torque | 30 Nm (22 ft. lb.) | |||
| Transmission bracket to body | Tightening torque | 65 Nm (48 ft. lb.) | |||
| Transmission bracket to transmission | Tightening torque | 120 Nm (89 ft. lb.) | |||
| Transmission holder | Tightening torque | 65 Nm (48 ft. lb.) | |||
| Anti-roll bar to suspension/stabilizer | Tightening torque | 23 Nm (17 ft. lb.) | |||
| Drive shafts | Fastening screws between drive shaft and transmission flange | Tightening torque | 81 Nm (60 ft. lb.) | ||
| Cable duct | Fastening screws between cable duct and transmission | Tightening torque | 10 Nm (7.5 ft. lb.) | ||
| B+ cable | Fastening screws for B+ cable | Tightening torque | 10 Nm (7.5 ft. lb.) | ||
| Holder for coolant lines | Fastening screws between holder and transmission | Tightening torque | 10 Nm (7.5 ft. lb.) | ||
| Cross member | Fastening screws between cross member and carrier side section | Tightening torque | 65 Nm (48 ft. lb.) |