LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Macan Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 132 (40 - Front Wheel Suspension, Drive Shafts -- PANAMERA (970)) >> WM 405019 Removing And Installing Front Wheel Bearing Housing (Except PANAMERA GTS, PANAMERA Turbo S, PANAMERA Platinum Ed., PANAMERA 4 Platinum Ed.) >> Preliminary Work

Preliminary Work

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. If the wheel bearing housing is replaced (all-wheel drive vehicles only): 

    Remove the relevant hub cap using puller hook 9229/1  and loosen axle nut (lock nut) -1-  before raising the vehicle. Operate the brake while doing this (2 mechanics required).

    Fig 1: Removing Axle Nut
    G09807368Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Raise the vehicle → 4X00IN LIFTING THE VEHICLE .
  3. Remove wheel → 440519 REMOVING AND INSTALLING WHEEL .
scientia non olet · About LEMON Manuals