Technical Values
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Lower wishbone to wheel carrier (taper bushing) | M14 x 1.5 thread | Tightening torque | 130 Nm (96 ftlb.) | ||
| Lower wishbone to spring strut | M12 x 1.5 thread | Tightening torque | 90 Nm (67 ftlb.) | +120° | |
| Steering spoiler (air guide) to lower wishbone with take-up hole | M6 x 50 thread | Tightening torque | 10 Nm (7.5 ftlb.) | ||
| Drive shaft to wheel hub (setting 1) | Setting 1: Before installing the wheel carrier, M22 x 1.5 thread | Tightening torque | 130 Nm (96 ftlb.) | ||
| Drive shaft to wheel hub (setting 2) | Setting 2: With wheel carrier installed, M22 x 1.5 thread | Tightening torque | 460 Nm (340 ftlb.) | ||
| Drive shaft to differential | M8 x 53 thread | Tightening torque | 22 Nm (16 ftlb.) | +90° | |
| Brake disc to wheel hub | M6 screw | Tightening torque | 10 Nm (7.5 ftlb.) | ||
| Cable holder to wheel carrier | M6 thread | Tightening torque | 10 Nm (7.5 ftlb.) | ||
| Brake calliper to wheel carrier | M14 x 1.5 thread (always replace screws and lock nuts after removal.) | Tightening torque | 140 Nm (104 ftlb.) | ||
| Tie rod to tapered end of wheel carrier | M12 x 1.5 thread | Tightening torque | 85 Nm (63 ftlb.) | ||
| Upper wishbone to tapered end of wheel carrier | M12 x 1.5 thread | Tightening torque | 85 Nm (63 ftlb.) |