Reading out transfer gear wear integrator

Information 

The transmission wear integrator oil  must be checked during every intermediate maintenance/maintenance.

1. Connect the Tester to the vehicle and start it. Switch on ignition.
2. Select the vehicle type if required.
3. Select the All-wheel  menu.
4. Select the Actual values, input signals  menu.
5. Select the T_wear integrators  menu. Press [F12] to continue.
6. V40_Transmission wear integrator - oil  must be selected. Press [F12] to continue.

   If this value is greater than 145 kWh,  the oil in the transfer gear must be changed → CHANGING OIL FOR TRANSFER GEAR . If the value is lower, no further action is required.

7. If the oil in the transfer gear is changed, the value must be deleted and reset to zero after the oil change.