Installing Solenoid/Hydraulic Valve For Camshaft Controller
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
Information
The tightening specifications for the basic engine are stored centrally.
> Refer to 1X001N Technical values in the appropriate service information.
> Refer to 2X001N Technical values in the appropriate service information.
or
> 1001IN TIGHTENING TORQUES, TIGHTENING SEQUENCES AND ASSEMBLY OVERVIEWS
Tightening torques and assembly instructions for other assemblies (e.g. chassis, electrics, transmission or body) or for peripheral engine equipment can be found in the corresponding documents.
- Replace sealing ring on hydraulic valve. Do not insert sealing ring twisted when fitting it.
- Coat sealing ring lightly with engine oil and insert hydraulic valve into the cylinder head. Any installation position is possible
- Fit and tighten fastening screws.
Camshaft control
1 Screw, M12 Tighten fully after setting valve timing. Always use a new screw 2 Camshaft controller with Integrated hexagon for countering 3 Hydraulic valve for camshaft control 4 Screw, M5 x 12