Removing Additional Brake Light

Masking rear spoiler 

1. 1.1. Mask the right-hand side of the rear spoiler underneath the additional brake light as shown

   → Masking rear spoiler  using fabric adhesive tape.

   NOTE:

   To prevent damage  to the additional brake light  , always observe the following installation sequence and never  use a plastic wedge or slotted screwdriver to lever the additional brake light out of the rear spoiler  .

2. 1.2. Carefully insert a plastic wedge at a horizontal position between the rear spoiler and additional brake light -arrow A  until there is a gap of approx. X = 3 mm  between the lower edge of the additional brake light and rear spoiler.

   Removing additional brake light 

   NOTE:

   • When removing the additional brake light, always use a small slotted screwdriver to move the locking lug to the left and unlock it through the widened gap.
   • Only release the additional brake light when part of the locking lug is visible through the gap. Use a hand lamp to check this if necessary.
3. 1.3. Insert a narrow screwdriver in the marked area of the gap and push the additional brake light locking lug lying behind it to the left to unlock it -arrow A-  until the additional brake light pops out slightly.

   Removing additional brake light 

4. 1.4. Carefully pull the plastic wedge and additional brake light out of the rear spoiler -arrow-  and leave the additional brake light hanging on the wire harness at the left.
5. 1.5. Remove the fabric tape you affixed to the rear spoiler earlier.

Electric plug connection