LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Macan S >> Repair and Diagnosis >> External Pages >> Different car >> Section 627 (10 - Engine - Crankcase, Suspension -- (95B) MACAN) >> WM 1001IN Lifting The Engine (Workshop Crane) (All Model Except For MACAN & MACAN Edition) >> Securing Engine To Engine Crane

Securing Engine To Engine Crane

WARNING: This page is about a different car, the 2018 Porsche Macan and 2017 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Heavy components
  • Risk of squashing

→ Wear personal protective gear.

→ Get someone to help if necessary.

WARNING: Danger of objects or loads falling down
  • Risk of squashing or crushing

→ Secure components to prevent them from falling down.

NOTE:
  • The pictures shown in this document may differ from the original. 
NOTE:
  • When removing the new engine from the transport frame, it may be necessary to raise the transport frame at the side (flat jack or similar). → Workshop crane and transport frame 
    • When removing the new engine from the transport frame, it may be necessary to safeguard the engine against lateral movement using a second worker and against scratching by covering it with a blanket. 
    G11980304

    Workshop crane and transport frame 

  1. Remove design cover on engine if necessary.
  2. Engage one hook of the lifting tackle 3033  in the rear transport eyebolt on the engine. Engage the other hook of the lifting tackle at the front of the engine. Raise the workshop crane slightly and tension the spindles slightly. The lifting tackle must be adjusted evenly. → Workshop crane and engine (V8 shown) 
    G11980305

    Workshop crane and engine (V8 shown) 

  3. Carefully lift the engine and balance it or separate the engine from the transmission, depending on what you want to do.
scientia non olet · About LEMON Manuals