LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Macan S >> Repair and Diagnosis >> External Pages >> Different car >> Section 625 (13 - Engine - CRANKGEAR, Pistons -- (95B) MACAN) >> WM, 137619A5 Removing And Installing Pulley (MACAN S) >> Removing Pulley (Vibration Damper)

Removing Pulley (Vibration Damper)

WARNING: This page is about a different car, the 2018 Porsche Macan and 2017 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
  1. 9697/3 - Counter-hold tool  with the rectangular tube from 9732 - holding wrench  must be inserted into the vibration damper and turned until it locks. Counter-hold tool in vibration damper 
    G00687059
    CAUTION: Incorrect handling of tools
    • Risk of damage to the body

    → Only use tools approved by Porsche.

    → Always ensure that the tool is seated correctly.

    → Protect the body and interior of the vehicle from damage with protective covers.

    → Cover delicate components with cardboard or sheetmetal panels.

    NOTE: Protect the radiator fins using cardboard or a sheetmetal panel to prevent damage.

    Cover wing and peripheral parts to protect them.

  2. Fit the large torque wrench or T-piece -2-  . Use a tubular handle if necessary -1-  .
    1. Undo the central screw of the damper. Do not use the screw again.
    2. Use a tubular handle -1-  if necessary.
      3. IMPORTANT: Loosening torque is very high.
    3. G11980369
  3. Remove central screw and pull vibration damper down and forward. Vibration damper 
    G00687067
scientia non olet · About LEMON Manuals