LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Macan S >> Repair and Diagnosis >> External Pages >> Different car >> Section 623 (40 Front Wheel Suspension, Drive Shafts -- (95B) MACAN) >> WM 405019 Removing And Installing Front Wheel Bearing Housing (Except MACAN Sport Edition) >> Preliminary Work

Preliminary Work

WARNING: This page is about a different car, the 2018 Porsche Macan and 2017 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the relevant hub cap using puller hook 9229/1  and loosen axle bolt -1-  before raising the vehicle. Operate the brake while doing this (2 mechanics required).
    G11983814

    Axle bolt 

  2. Raise the vehicle → 4X00IN LIFTING THE VEHICLE .
  3. Remove wheel → 440519 REMOVING AND INSTALLING WHEEL .
  4. Support wheel bearing housing (in order to avoid damage to the joints on the upper trailing arms).
    G11983815

    Mounting for support T10149 

    1. 4.1. Turn the wheel hub in such a way that a bore for a wheel bolt is at the top.
    2. 4.2. Support T10149  must be secured to the wheel hub with a wheel bolt -arrow- 
    3. 4.3. Support T10149  must now be fitted into the transmission jack WE 1082  .
  5. Remove lower trailing arm → 401719 REMOVING AND INSTALLING LOWER TRAILING ARM .
  6. Loosen holder -1-  for brake line, wear indicator and speed sensor on the wheel bearing housing.
    G11983816

    Holder on wheel bearing housing 

  7. Remove front speed sensor → 451155 REPLACING FRONT SPEED SENSOR .
  8. Remove brake calliper and suspend it at a suitable position in the wheel housing (do not open the brake hydraulic system!) → 473919 REMOVING AND INSTALLING FRONT BRAKE CALLIPER .
  9. Remove brake disc → 465019 REMOVING AND INSTALLING FRONT BRAKE DISC .
scientia non olet · About LEMON Manuals