Test conditions
WARNING: This page is about a different car, the 2018 Porsche Macan and 2017 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Always pay particular attention to the following before raising the vehicle:
- Deactivate the levelling system before raising the vehicle (press and hold the levelling system button for at least 10 seconds).
- If a transmission range is engaged while the vehicle is raised, the levelling system must first be deactivated using PIWIS Tester II 9818 . To do this, select >>Levelling system/PASM<<>>Drive links/checks<<>>Activate/deactivate levelling system (without wheel rotation detection)<< in the control unit overview. Select the value "Deactivate levelling system (permanently)" and press "Start" [F8] to execute the function. Re-activate the levelling system when the work is complete. To do this, select >>Drive links/checks<<>>Conclude initial commissioning>> and then select "Activate levelling system" under >>Activate/deactivate levelling system (without wheel rotation detection)<< and execute the function by pressing "Start" [F8].
- All functions (e.g. ventilation/filling) of the PASM control unit are deactivated as soon as the levelling system has been deactivated using the function >>Activate/deactivate levelling system (without wheel rotation detection)<<.
- Transmission must not be in limp-home mode.
- Warm up transmission in lower load range. Switch all transmission ranges several times while doing so.
- Read out the ATF temperature using the PIWIS Tester .
- ATF temperature: 30 - 50 °C.
- Selector lever is in position P.
- Parking brake actuated.
- Test and filling process at idle speed.
- Air conditioning and heating switched off.
- The ATF temperature must not be higher than 30 °C at the beginning of the test.
- If the ATF temperature is higher than 30 °C, let the transmission cool down.