LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Macan S >> Repair and Diagnosis >> External Pages >> Different car >> Section 609 (68 Interior Equipment -- (95B) MACAN) >> WM 683419 Removing And Installing Covering Frame For Centre Console (Except MACAN Sport Edition) >> Removing Covering Frame For Centre Console

Removing Covering Frame For Centre Console

WARNING: This page is about a different car, the 2018 Porsche Macan and 2017 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • The number of fastening screws, fixing clips, plug connections, holders and trim panels can vary depending on equipment  .
  • The illustrations for removing and installing the drive mechanism are shown only on one equipment variant and may differ from the actual equipment variant  .
  • Some steps must be carried out automatically  .
  • Some of the repair illustrations show only one side of the vehicle  .
  1. Move front seats to the very front position.
  2. Unclip covering frame -1-  in the upper area -arrows-  on the center console -2-  and guide it out.
  3. Unclip covering frame -1-  at all fixing clips and remove from the center console -2-. 
    G11981505

    Mounting for covering frame for center console 

  4. Release electric plug connection -1-  for the 12 V socket and disconnect it.
  5. Release and disconnect electric plug connections -2-  at the rear seat heating controls.
  6. Release electric plug connection -3-  for KESSY antenna and disconnect it.
  7. Remove covering frame -4-. 
    G11981506

    Electric plug connections for covering frame 

scientia non olet · About LEMON Manuals