Installing Padding For Front Backrest
WARNING: This page is about a different car, the 2018 Porsche Macan and 2017 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
Information
Detach padding from the cover and secure it, see → 741755 REPLACING PADDING FOR FRONT BACKREST
- Pull padding with cover over the backrest frame from above.
- Align padding with cover on the backrest frame -arrows A-
.
Aligning cover for backrest
- Pull the cover and padding back between the seat surface and backrest -arrows B- .
- Plug in electric plug connection for seat heating -1-
(-A-
) until the connector engages securely.
Plugging in connector for seat heating
- Tighten fastening screws -3-
for ISOFIX clips -4-
(Tightening torque 7.5 Nm (5.5 ftlb.) +/-0.5 Nm (+/-0.5 ftlb.)
).
Securing restraining strap
- Clip in seat cover at the rear -2- in an upward direction.
- Engage restraining strap -1- at the left and right.
- Fit fixing clips -1-
.
Engaging cover in cut-out for the backrest cover
- Engage the cover in the cut-out for the backrest cover all the way around -arrows- .