Removal And Installation: Installation
WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, 2016 Land Rover Range Rover, 2015 Land Rover Range Rover, and 2014 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
-
CAUTION: Care must be taken not to damage the body work.
- Install the fuel filler pipe.
- Tighten the nut and bolt.
Torque Specification: 10 Nm
- Install new front subframe bolts finger tight.
Renew Part: Rear subframe to body bolts Quantity: 1 .
-
NOTE: Repeat this step for the other side.
Install the front subframe support bracket bolts.
Torque Specification: 60 Nm
- Fully tighten the rear subframe bolts.
Torque Specification: 170 Nm
- Remove the transmission jack.
-
NOTE: Repeat this step for the other side.
Install the bolts and clip.
- Install the driveshaft.
Refer to: REAR DRIVESHAFT - V6 S/C 3.0L PETROL/V8 N/A 5.0L PETROL/V8 S/C 5.0L PETROL
- CAUTION: Nuts and bolts must be tightened with vehicle at normal ride height.NOTE: Repeat this step for the other side.
- Support the lower arms with suitable axle stands.
- Install a new nut and bolt to the shock absorber.
Renew Part: Shock absorber nut and bolt Quantity: 1 .
Torque Specifications:
Stage 1: 100 Nm
Stage 2: 240°
-
NOTE: Repeat this step for the other side.
Install the air suspension hoses to the body.
Connect the electrical connector.
- Install the breather hose on to the fuel filler pipe.
- Install the evaporative emission cannister hose.
- Install the right rear wheel arch liners.
Refer to: REAR WHEEL ARCH LINER
- Install the rear road wheels.
Instal the nut on to the fuel filler pipe.
-
- Install the fuel filler flap assembly.
- Install the trim around the fuel filler pipe.
- Install the fuel filler cap.
- Using the Land Rover approved diagnostic system, pressurize the air suspension.