Neutral Gear Switch - Adaptation (Manual Transmission Only)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Necessary after:

Re-programming DME control unit
Replacing DME control unit
Deleting adaptation values (see above)

Necessary before:

Carrying out plausibility check on neutral gear switch to enable Start Stop system

How?

Drive in 1st gear
1. 1.1. Clutch released fully
2. 1.2. Accelerate to around 30 km/h (20 mph)
3. 1.3. Release accelerator pedal and allow vehicle to roll with gear engaged (engine overrun) up to around 10 km/h (6 mph)
Drive in 2nd gear
1. 2.1. Clutch released fully
2. 2.2. Accelerate to around 30 km/h (20 mph)
3. 2.3. Release accelerator pedal and allow vehicle to roll with gear engaged (engine overrun) up to around 10 km/h (6 mph)
Vehicle is stationary
1. 3.1. Clutch released fully
2. 3.2. Shift lever in neutral position.
  Do not touch shift lever for 10 seconds
Switch off ignition