LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Macan S >> Repair and Diagnosis >> External Pages >> Different car >> Section 132 (40 - Front Wheel Suspension, Drive Shafts -- PANAMERA (970)) >> WM 405019 Removing And Installing Front Wheel Bearing Housing (Except PANAMERA GTS, PANAMERA Turbo S, PANAMERA Platinum Ed., PANAMERA 4 Platinum Ed.) >> Subsequent Work

Subsequent Work

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Fit the wheel. → 440519 REMOVING AND INSTALLING WHEEL

  1. Tighten axle nut (drive shaft mounting on wheel side) (2-step tightening procedure!). Operate the brake while doing this (2 mechanics required). → 4X00IN TIGHTENING TORQUES FOR FRONT AXLE

    Information 

    Vehicles with steel suspension: Tighten lower threaded joint in installation position.

  2. Perform suspension alignment. → 449503 SUSPENSION ALIGNMENT, COMPLETE
scientia non olet · About LEMON Manuals