LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Macan S >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (85 - Ventilation -- PANAMERA (970)) >> WM 852219 Removing And Installing Plenum Panel Cover (Except PANAMERA S Executive, PANAMERA Executive, PANAMERA 4 S Executive, PANAMERA Turbo Executive, PANAMERA GTS, PANAMERA 4S Sport Edition, PANAMERA 4 Executive) >> Installing Plenum Panel Cover

Installing Plenum Panel Cover

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position plenum panel cover.
  2. Screw in and tighten the three fastening screws -1-  .
    Fig 1: Installing In Fastening Screws
    G09813243Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Pull the end -1-  of the front profile seal over the retaining lug -2-  .
    Fig 2: Hooking In Profile Seal
    G09813244Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    1. 3.1. Hook the end -1-  of the front profile seal into the retaining lug -2-  and press it on.
  4. Fit the rear profile seal on the lid -1-  and press on firmly from the inside out.
  5. Press the foam corner piece -3-  onto the profile seal.
    Fig 3: Fitting Rear Profile Seal On Lid
    G09813245Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals