Installing exhaust system

Installation is performed in reverse order. Pay particular attention to the following:
1. 1.1. Align exhaust-system mount.
2. 1.2. Tightening torque for nuts securing rear silencer holder to body: Tightening torque 20 Nm (15 ft lb.)
3. 1.3. Tightening torque for screws securing rear silencer holder to rear body: Tightening torque 20 Nm (15 ft lb.)
4. 1.4. Tightening torque for nuts on clamp: Tightening torque 30 Nm (22 ft lb.) +/-5 Nm (+/-3.5 ft lb.)
5. 1.5. Align clamp.

3 mm /Clip contour must not be lower than the lower edge of the clamping sleeve.

G12833860

Courtesy of PORSCHE CARS NORTH AMERICA, INC.