Installing motor for sun blind
WARNING:
Electrically moved components
- Danger of limbs being trapped or severed
→ Switch off electric power to drive motor.
→ Make sure it does not switch on again.
→ Check that there is no electric charge.
Information
Always comply with the regulations for handling ESD-sensitive components!
- Always wear approved work clothes and shoes when carrying out assembly work .
- Do not remove new parts from ESD (electrostatic discharge) protective packaging until shortly before installation .
- Do not touch electric pins and plug contacts .
- Installation is performed in reverse order to removal.
- Replace and tighten fastening screws securing motor for sun blind to glass sliding roof frame. Tightening torque 2 Nm (1.5 ft lb.)