Installing tail light
Information
If a new tail light is installed, the following spacers/gel pads must be affixed at defined positions on the tail light before installation.
| 1 | Affixing 1-mm gel pad. For part number, see Tail light in PET. |
| 1 | Affixing 1-mm gel pad. For part number, see Tail light in PET. |
| 2 | Affixing 2-mm gel pad. For part number, see Tail light in PET. |
| 1 | Affixing 1-mm gel pad. For part number, see Tail light in PET. |
| 2 | Affixing 2-mm gel pad. For part number, see Tail light in PET. |
- Installation is performed in reverse order to removal.
- If the tail light was replaced, set the gap dimensions by turning the adjustment device.
- Tighten fastening screws on the tail light.
- Screw on and tighten fastening nuts on the rear retaining strip.
- Tighten fastening screw used to secure the rear retaining strip to the front retaining strip.