Information on transfer gear with GNC plates: Notes

Information

Transfer gear with gas nitrocarburised (GNC) "hardened" steel plates.

If the transfer gear is replaced, the software must always be adapted .
For transfer gears with GNC plates, only the all-wheel software version 1360 (Part No.: 95B927755CB) I-no. LU2 must be used .

Transfer gear

Porsche part number of control unit after commissioning

Software version of control unit after commissioning

Part number on transfer gear

PR number⁽¹⁾

PET2 Parts Catalogue

without GNC

95B927755BJ

1204

95B341010

with GNC

95B927755CB

1360

95B341010 A

LU2

95B341010 A

⁽¹⁾

(Can be read out of the vehicle order: [F7] Additional menu -> Maintenance of vehicle data) The PR number is written automatically during commissioning (only for control unit replacement including transfer gear). For vehicles produced from week 12/2018, this is assigned to the vehicles at the factory. The relevant software is programmed using the Tester based on the PR number.