LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Macan S >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Differentials & Drive Axles >> 39 - Final Drive - Differential, Differential Lock >> WM 396519 Removing and installing transfer gear >> Installing transfer gear

Installing transfer gear

  1. Install transfer gear with vibration balancer.
    1. 1.1. Check splines on the transfer gear and apply grease all around it if necessary.
    2. 1.2. Replace screws.
    3. 1.3. Fit transfer gear and tighten screws hand-tight.
    4. 1.4. Tighten screws in the sequence -1-5-  to Initial tightening 50 Nm (37 ft. lb.) Final tightening +90°  until secure.
      Fig 1: Transfer Gear Screws Tightening Sequence
      G12834378Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Connect electric connector -1-  to the control unit.
    G12834379Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. If the transfer gear is replaced, new software must be installed.
scientia non olet · About LEMON Manuals