Technical values

TORQUE SPECIFICATION

Location	Description	Type	Basic value
Connecting link to anti-roll bar	M10 x 65 thread/always use new screws and nuts following removal	Initial tightening	50 Nm (37 ft. lb.)
Connecting link to anti-roll bar	M10 x 65 thread/always use new screws and nuts following removal	Final tightening	+90°
Connecting link to lower trailing arm	M10 x 65 thread/always use new screws or bolts following removal	Initial tightening	50 Nm (37 ft. lb.)
Anti-roll bar clamp to rear axle carrier	M8 x 65 thread/always use new screws following removal	Initial tightening	20 Nm (15 ft. lb.)
Anti-roll bar clamp to rear axle carrier	M8 x 65 thread/always use new screws following removal	Final tightening	+180°
Heat shield for drive shaft to rear axle	M8 x 22 thread	Tightening torque	20 Nm (15 ft. lb.)
Level sensor to lower trailing arm	M6 x 16 thread	Tightening torque	9 Nm (6.5 ft. lb.)
Connecting link to lower trailing arm	M10 x 65 thread/always use new screws or bolts following removal	Final tightening	+90°