Subsequent work

Information 

• Grease the part of the speed sensor located in the wheel bearing housing.  .
• The bore for mounting the speed sensor must be free of dirt  .
• Observe specified tightening torques  .

1. Insert speed sensor -2-  and tighten fastening screw -1 -  . Tightening torque 8 Nm (6 ft. lb.) 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

2. Position cover plate for brake disc -2-  and tighten fastening screws -1-. Tightening torque 10 Nm (7.5 ft. lb.) 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

3. Install wheel bearing housing. → 425219 REMOVING AND INSTALLING REAR WHEEL BEARING HOUSING