Technical values
TORQUE SPECIFICATION
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Lower control arm to wheel bearing housing | M14 thread/always use new nuts following removal | Tightening torque | 140 Nm (104 ft. lb.) | ||
| Upper trailing arm to wheel bearing housing | M10 thread | Tightening torque | 45 Nm (33 ft. lb.) | ||
| Brake cover plate to wheel bearing housing | M6 x 14 thread | Tightening torque | 10 Nm (7.5 ft. lb.) | ||
| Holder to wheel bearing housing | M6 x 16 thread | Tightening torque | 10 Nm (7.5 ft. lb.) | ||
| Drive shaft to wheel hub | Step 1 (wheels suspended in the air, press brakes while tightening)/M16 x 72 thread/always use new screws or bolts following removal | Tightening torque | 200 Nm (148 ft. lb.) | ||
| Drive shaft to wheel hub | Step 2 (wheels on the ground)/M16 x 72 thread/always use new screws or bolts following removal | Torque angle | 180° |